Thermocouples are manufactured from two electrical conductors using two dissimilar metal alloys joined together at one end that produce a specific millivolt signal at a given temperature. This signal is then measured and interpreted by a thermocouple thermometer. The conductors are typically built into a cable with a heat-resistant sheath. At one end of the cable, the two conductors are joined together by welding. This end of the thermocouple (the hot junction) is thermally attached to the object to be measured. The other end (the cold, or reference junction) is connected to a temperature measurement system. The thermocouple gives you temperature readings at the hot junction point.

Typically, Thermocouples are available in four different combinations of metals or calibrations: J, K, T and E. Each calibration has a different temperature range and environment. With each of the four combinations, the maximum temperature varies with the diameter of the wire used in the thermocouple.

Because thermocouples measure in wide temperature ranges they are widely used in many fields of industry. When selecting a thermocouple you must consider: temperature range; corrosive or chemical resistance of the sheath material; abrasion and vibration resistance and installation requirements.

Sheathed thermocouple probes are available with one of three junction types: grounded, ungrounded or exposed. At the tip of a grounded junction probe, the thermocouple wires are physically attached to the inside of the probe wall. This results in good heat transfer from the outside, through the probe wall to the thermocouple junction. In an ungrounded probe, the thermocouple junction is detached from the probe wall. The thermocouple in the exposed junction style protrudes out of the tip of the sheath and is exposed to the surrounding environment. This type offers the best response time, but is limited in use to noncorrosive and moisture-free applications.

A time constant has been defined as the time required by a sensor to reach 63.2% of a step change in temperature under a specified set of conditions. Exposed junction thermocouples are the fastest responding. Also, the smaller the probe sheath diameter, the faster the response, but the maximum duration may be lower.

It is a sensor used for determining temperature. It consists of diverse metals joined at the ends in a single connecting point. This connecting point generates electric energy when the temperature of one end differs from the other. The wire is commonly used to link the thermocouple to control instrumentation. It may also be used to build the sensing point.

Thermocouple grade wire is wire that is used to make the sensing point of the instrument, where extension grade wire is only used to extend a thermocouple signal from a probe back to the instrument reading the signal.

All MgO insulated thermocouples are made using the highest purity MgO for temperatures up to 2300°F (1260°C). The thermo-elements are all ANSI special limits of error to give your measurements the best possible results. The various sheath materials are dependent upon the application, including 304 SS, 310 SS, 316 SS, Inconel® and Hastelloy X.

The insulation is usually color coded for easy identification. There are some common guidelines for the colors. The negative lead in insulated wire is red, while the positive lead has the color of the thermocouple. The outer jacket of thermocouple grade wire is typically brown. For high temperature wire, it is common to have a color-coded tracer thread in the white material.

Thermocouple sheath diameter should be selected according to the required temperature range and application. Standard sheath diameters range from .020” to .250”, with suggested upper temperature limits ranging from 1290°F (700°C) to 2100°F (1150°C).